High Speed Service

Low Speed   |   Electric Handpiece

What is a High Speed Turbine Rebuild?

When your handpiece stops working, it is usually because the turbine bearings are worn and need replacement.  Our turbine rebuild offers a more economical alternative to replacing the entire turbine every time.  We carefully remove the old bearings and any other parts too worn to use.  After a thorough cleaning, we install new bearings and o-rings, calibrate, test your handpiece, and return it to you running almost as good as new.

Ceramic Bearings

We exclusively use ceramic ball bearings in our high speed repairs.  A ceramic ball is lighter, approximately 60%, and smoother than a comparable steel ball.  These properties allow the ceramic ball to create less friction when operating at maximum speeds.  The reduction in friction produced heat minimizes the wear on the bearing outer raceway.  Ceramic balls are harder than steel balls offering better protection against damage from external contaminants or bearing wear debris.  With proper maintenance, the ceramic ball bearings can yield a longer life span over traditional steel ball bearings.

 

High Speed Turbine Rebuild

Six Month Warranty

 
ADEC   $99  
Impact Air 45   $99  
Kavo 600 Series   $99  
Kavo 4500 & 6500 $129  
Kavo Master/Expert/Smart $129  
Lares   $99  
Midwest (All Except Stylus)   $99  
Midwest Stylus/Stylus Plus/ Tradition Pro $129  
NSK (All Except NL9000)   $99  
NSK NL9000 $129  
Star 430 SWL (Lubricated)   $99  
Star 430 Lube Free $129  
Vector   $99  
Push Button Canister Rebuild   $99  
Push Button Canister New   $149    
Standard Canister   $79  


What is an Autochuck Repair?

When the automatic chuck (pushbutton or lever) in your handpiece turbine stops gripping the bur safely you have two options. You can replace the entire turbine with a new turbine, or we can repair, or sometimes replace, just the autochuck and get it to meet factory specifications again. This is a separate repair from the turbine rebuild, and carries a separate six month warranty. If your bearings are in good enough condition then the only charge will be for the autochuck repair by itself. If we are not able to repair or replace your autochuck, we will then recommend a new turbine.

  • Autochuck Repair/Replacement (Six Month Warranty)  -  $90

Additional High Speed Handpiece Services

  • Fiber Optic Replacement  -  $199 -$275
  • Star Body Shell Service  -  $75
  • Air/Water Line Clearing, Minor Service  -  $50
  • Internal Air/Water Line Replacement  -  $110